Issue 112 2017-02-17 購読

POLYSTAR- Twin head blown film machine for bag production

Normally when producing film rolls for T-shirt and various bag conversion which ranges from 300~700mm in width, it is difficult to achieve higher output by using a bigger extruder for such small film width unless the blown film extruder is equipped with an internal bubble cooling.Normally when producing film rolls for T-shirt and various bag conversion which ranges from 300~700mm in width, it is difficult to achieve higher output by using a bigger extruder for such small film width unless the blown film extruder is equipped with an internal bubble cooling.

One Layer Twin Head HDPE LDPE LLDPE 800mm

Twin head blown film machine

Dual-Flex

	Twin head blown film machine
	High efficiency for bag production

The twin head blown film machine offers an economic alternative and has a much faster return on investment comparing to a blown film machine installed with internal bubble cooling system (IBC).
In the twin head blown film machines, 1 die head can reach much higher output with a bigger extruder (such as 55mm, 65mm or 75mm in diameter) even when producing smaller width film. It is especially effective for T-shirt bag makers who are looking for machine with higher output but lower cost.Comparing to extruders with a single die head, the twin die extruders can achieve higher production capacity when producing film roll that are small in width, as the high extrusion output is dispersed into two separate channels of the die heads instead of one.

Polystar designs and customizes this type of twin head blown film machine with different screw diameter and roller width depending on the customers’ requirement. Available in screw diameter of 55mm, 60mm, 65mm and 75mm and film width from 400mm up to 800mm on each winder.The double head blown film machine also allows producers to switch between HDPE and LDPE production as well as producing different film width on the same machine on each winder simultaneously.

A special screw design is used to provide good mixing and stable output for both HDPE and LDPE material. Bimetallic treatment can be applied (optional) to process a higher percentage of recycled material and CaCO3 compound. Polystar uses Siemens/ABB Baldor energy saving motors for the extruders which can reduce energy consumption up to 5%. POLYSTAR has installed more than 400 sets of its twin head blown film machines in many leading T-shirt bag makers' factory worldwide.

More details on POLYSTAR blown film machine